Setting Rotary Position to Home Upon completing the installation procedures for your Rotary attachment, you will want to ensure that your home position is aligned correctly. The following will guide you through this alignment. The Red Diode Pointer 1. Using the left and right arrow keys on your LCD Display, select the SETUP button the LCD Display. The Diode Pointer projects a red beam of light, which will pin point the home position of your rotary attachment. 2. Using the down arrow keys, scroll down to the “Diode Pointer” and select “Yes” by turning the round knob on the display to the right. Press “Enter”. … Continue Reading

Using the Epilog Rotary Attachment

Files

http://www.engrave.ca/files/mug_template_v8.cdr
http://www.engrave.ca/files/mug_template_with_different_turns_v8.cdr
http://www.engrave.ca/files/mug_template_with_no_turn_v8.cdr
One of the more intimidating techniques to learn on the laser engraver is how to use the rotary attachment. This help file should help eliminate any misgivings you may have.

1. If your table is not lowered than lower it down about 5 inches
2. Turn the power off to the machine
3. Plug in the rotary machine (the plug is under the left side of the machine (EX or LX and the front of the machine on the TT).
4. Turn the machine on.
5. The machine will know that the rotary attachment is plugged in and the X axis will settle over the attachment – see Figure 1.

Figure 1

6. Place your glass item in the attachment. Now the big question is where do I place my image? To answer this let us look at setting up the image in CorelDraw first. … Continue Reading